Quote:
BellyDoc previously said:
I have a F'ing frozen Morris taper tool holder in my milling machine and I'm going to have to get serious with a hammer before I can cut steel with any precision again. Every time I walk by it, I squirt it with a little Break-Free in the hope that I'm contributing to penetration... It's not going well.
|
If it's actually a Morse taper that can be a b*tch. I've run into problems disimpacting Morse tapers on several occasions. It's wierd how somehow just the right little tap will suddenly knock it apart. Sometimes certain vibrations seem to help. Also, depending on how it's configured you may be able to get a puller of some sort over it. Also, you might try heating up the out part a bit to see if it will expand a bit relative to the inner part.
__________________
www.rapidfj.com
DISCLAIMER: Everything you read in my posts is written for entertainment. Any similarity to actual people, places, things, events is entirely coincidental. Any action or inaction that you may or may not take is your responsibility -- not mine. Don't let me influence you in any way. If you're under 18 or otherwise unable to take legal responsibility for your own thoughts and actions then don't read my posts. If you don't have a sense of humor, then piss off!
