Your finished Allpro bumper pics

[GOFJGO]

Here's my bumper finished off. I had the whole thing powdercoated silver first then had the top of it Line-X'ed along with the lower skid plate. Then I had the baja bar powdercoated to match the bumper. Waiting for my Warn winch to come in then I'll install the whole thing at one time. sorry about the poor quality pic

[bigbill25]

Looks interesting. I'll be interested to see what it looks like on the truck!

--Bill

[Son of a Son]

The linex looks like it has black sand on it. Almost like wing walk.

[Landrover]

Nice and original. And yes....that is one crappy photo

[gsgmac]

The break between the line-x on the top bumper and the silver does not look even. May be the pic though.

[Sun Fusion Cruiser]

That's an interesting look, I like it.

[Bad Voodoo]

I'm curious... Will the winch control access holes on either side of the fairlead accommmodate 3 or 4-inch fog lights like the PIAA Ion Crystals? If not, and if AP checks this thread out, can they be modded to accept lights?

-voodoo

[GOFJGO]

The pic is terrible but the line is nice clean, just as clean as when they roll the material over the top of a truck bed. The finish on the bumper is smoother than it looks it's pretty close to the finish on the fenders.

[RocKrawler]

Anything can be done, but the drivers side hole is the access to the winch clutch knob, installing a light would make turning the knob difficult if not impossible

[Bad Voodoo]

RocKrawler previously said:

Anything can be done, but the drivers side hole is the access to the winch clutch knob, installing a light would make turning the knob difficult if not impossible

Don't need a winch (yet), so was interested in the non-winch AP bumper, until the realization that I like to run a 3-4" fog specific light down low and about a 6" driving light on the hoop. Those holes, if sized correctly would be perfect for a PIAA 510 fog, and would allow me to retain the flexibility to install a winch if/when I ever needed to.

-voodoo