ARB Safari Snorkel Install Instructions w/ Pics

[dangerous dan]

anyone figure out how to do the TRD CAI and Snorkle together yet?

[Shadow-Warrior]

dangerous dan previously said:

anyone figure out how to do the TRD CAI and Snorkle together yet?

Ah yeh...Look at the thread snorkle and CAi install...I'll find a link for ya, give me a minute....

[Shadow-Warrior]

Here is a link ARB Safari Snorkel to CAI Install w/Pics

It's a "sticky" in the 4x4 section at the top of the page in green.

Mike

[dangerous dan]

thanks

[bandi]

JAXTOY previously said:

Great pictures, you guys did some real muddin. The interior looks like it's gunna need some work. You guys are "crazy".

LOLOL... I missed this one... Yeaa, I still have
not cleaned it up, I did spend an hour with some
windex and some paper towels this past week
(the first time I have cleaned the interior), but
did not touch the floor... It's like the mud stained
the plastic on the doors, no mater how much
you spray and wipe, it's still visable, strange...

Most of the mud/water just poured out upon
putting the fj on a steep angle with the door
open, and the rest was dryed before noon that
day... ...

[dangerous dan]

I have a dumb question for you scuba divers

What happens to your wench when you submerse it

[Shadow-Warrior]

Nothing.....it gets wet like everything else.....It dosn't hurt the Winch.....

[Wolf]

dangerous dan previously said:

I have a dumb question for you scuba divers

What happens to your wench when you submerse it

She drowns... but on the brighter side, she would probably confess to any crime you'd like her to in the process.

Howls,
FJ Wolf

[JAC]

Ok, this might be a dumb question but I haven't been able to find the answer yet so here it goes:

How can you make sure that the snorkel is properly installed and thus truly watertight? (other than diving into a lake and hoping for the best, of course )

I was thinking about removing the air ram thingie and then covering the intake with a plastic bag while the engine is still running, if the snorkel truly is watertight then the engine should stall, right? is this a good way to test it or will I end up damaging something?

Thanks

[dangerous dan]

Imho I think even if you get a little water in with the snorkel it will likely not make it to the engine