All Pro Rear Swingout Can Rack Available NOW!

[RocKrawler]

For some time now FJ Owners have realized that a small fuel tank and mediocre mileage limit the range of off road exploration they can do without adding an expensive auxillary tank, or carrying extra fuel cans. Until now fuel cans had to be mounted up on the roof rack (raising the center of gravity and making access and filling difficult) or using a carrier that bolted to the spare tire (increasing load to the rear door and hanging further off the back, compromising departure angle). After over a year of development All-Pro is proud to announce our rear bumper swingout can and accessory rack. We have designed the rack to accept two 5gal or 20L fuel or water cans and attach to the All-Pro rear bumper, so no additional weight is carried on the rear door. In addition to the cans other accessories like Hi-Lift jacks and more can be attached using the FourTreks mounts we offer as well. Now fueling up and carrying Jerrycans is easy and safe, and the center of gravity is kept low for vehicle stability. Call All-Pro today and order yours now!

Official introductory pricing is $599 for bare steel and $699 for powdercoated - we have a very limited 1st run supply in stock. They will fit only on the All-Pro rear bumper and fit around up to a 35" tire, it will not fit around a 37". If you are local we strongly suggest picking it up at our shop as it is an oversize part and shipping will apply. Weight is 60lbs. It is being added to our website along with more pictures for online ordering, but phoning in is recommended to get an accurate shipping quote.

All-Pro Off Road 951-658-7077



Add cans and the FourTreks Hi-Lift mount & Hi-Lift Jack:

[RocKrawler]

One of our first customers had this to say:

skersfan previously said:

I picked up mine last Friday and used it at Johnson Valley this past weekend. It makes the truck so much quiter with the jack on the back. Did several tough crossings and it never got near touching the ground. Very stable when released and locks firmly. I have two fuel cans on mine and it works flawlessly.

Great job! Well worth the wait.

[MrsTennesseeSquire]

Awesome job and looks great!

[volhoo]

What are your plans for relocating the license plate?

-

[RocKrawler]

Jon is working on that now, likely going to be tabs on the horizontal bar and a lighted license plate frame

[bc_indiana]

that is one sick gas can holder. Props to the design team on that one.

Nice protection for the tire too. Now the blinds spots of the FJ seem more bearable!!!

[EschObfus]

You could easily tack on some bolts under the center loop cross bar for the license plate.

[MrsTennesseeSquire]

It looks like it just bolts on to the existing All-Pro Bumper, is this correct?

[CtheProducer]

Nice!

[RocKrawler]

MrsTennesseeSquire previously said:

It looks like it just bolts on to the existing All-Pro Bumper, is this correct?

Yes, drilling is necessary but we did the install in under 2 hours - thats with stopping to take pictures for the instruction sheet and writing down notes!