very cool,but I still want the rear bumper to match the front. Please,pretty please
I will be working on that soon also. I'll be honest we are running really low on guys at the shop! We are working as fast as we can to keep up. The second we get some time or I can find some more welders we will be back on track. Were going to finish up the skid plates then start on the rear bumper. hang in there
If no pics, how about a description or comparision to one of your other sets?
Sure, it will have two holes in the upper section to help keep it lite while also providing air flow. We did a cut out near the front diff so we could make the skid plat as high as possible. The cut out section will be welded back in place so you will gain 3\16in clearence on that section of skid plate. We also did wrap the front of skid up the front cross member for extra support. and of course the bolt holes are all recessed!
It's hard to describ but I will have pictures soon.
I will be working on that soon also. I'll be honest we are running really low on guys at the shop! We are working as fast as we can to keep up. The second we get some time or I can find some more welders we will be back on track. Were going to finish up the skid plates then start on the rear bumper. hang in there
you need to get some 9 year olds from china that weld.
Sorry guys the skids were taken back, there was a mistake, they are being pushed back about a week. I knew I shouldn't have posted till I had them in my hand. Sorry for the delay.
Linear Mode
