Are the mounting studs and bolts stainless? Haven't seen mine yet.
Quote:
slither previously said:
Hey guys just a little note. The badges are being shipped with two mounting studs per badge and two nuts for the two posts. There is no backing plate. The vendor had experienced problems with providing these in the past so he does not include them. Just an FYI. If you go to the Depot or Lowes they sell small lengths of 1/2" and 3"4 x 1/8" aluminum flat stock. Cut a piece 3-1/2" long. Drill two 3/16" holes 2-1/4" on center (2-1/4" measured from center of hole to center of hole. This will make a backing plate. You can also use fender washers or as one of my guys did with the FJNortheasters Badge, use a 1/2 no mortise hinge! Yup ingenuity!Please do not forget to empty the package when you receive it, I will not be sending out additional mounting posts for any reason. It is just not cost effective.
Hey...ah... Vince, do you think you could have found a little more inconspicuous spot to put it? I'm thinkin' you should mount it on the headlight screen!Nice job on the design, it came out great!
Holy Moly...His is the Steath Badge, lurking and hiding behind the light.
Mine will be up front and proud...the design is just too good, a clean marriage of the new FJC, the Forum, and the history of the FJ series and early days of Toyota. Too cool, can't wait for mine
__________________ 2007 Voodoo Blue /Option Package 2 / MT in Wyoming Ohio
OME Med / Med 3"
285/70/17 Dick Cepek FCII
Trail Gear Sliders
Full Leather Interior
My Legends before this FJ:
'74 FJ40
'82 FJ60
'84 FJ60
'94 FJ80
'79 FJ40
Please do not forget to empty the package when you receive it, I will not be sending out additional mounting posts for any reason. It is just not cost effective.
Nice job on the design, it came out great!
Linear Mode
