The RAPTOR (Shadow Warrior's Build) - Page 51

CRAW · 03-27-2008, 08:37 PM

Quote:

Shadow-Warrior previously said:

No, I removed the plastic tuppaware fenders and mud flaps too.

I see now - thanks. So, do you have a pic of RAPTOR from the side with them off?

Man, and just to think, if I had about 10k to spend I could get my ride close to lookin' like yours. HA!

**FJCamel** · 03-27-2008, 08:38 PM

Quote:

Shadow-Warrior previously said:

No, I removed the plastic tuppaware fenders and mud flaps too.

I am doing it on saturday... but my wheels are going to stick out even more

More carnage on the body

***Shadow-Warrior*** · 03-27-2008, 08:42 PM

Quote:

CRAW previously said:

I see now - thanks. So, do you have a pic of RAPTOR from the side with them off?

Man, and just to think, if I had about 10k to spend I could get my ride close to lookin' like yours. HA!

It would take a little more than that...

, maybe double that figure, and were getting close...

CRAW · 03-27-2008, 08:44 PM

Quote:

Shadow-Warrior previously said:

It would take a little more than that...

, maybe double that figure, and were getting close...

HA! Deep sea diving for oil companies must have been very nice to you. Nicely done sir!

***Shadow-Warrior*** · 03-27-2008, 08:49 PM

Thanks

***Fjamming*** · 03-30-2008, 05:31 PM

Mike, when is the Gobi coming in? Can't wait to see the RAPTOR with Gobi.

***Shadow-Warrior*** · 03-30-2008, 06:43 PM

Quote:

Fjamming previously said:

Mike, when is the Gobi coming in? Can't wait to see the RAPTOR with Gobi.

Me Too Tony...It should be in a few weeks I think, they should have started on mine at the end of last week...I can't wait, this has been the hardest MOD to decide on....It has taken months to decide on which roof rack, but I think the wait will be well worth it. I really love the look of the Ranger and the quality of the rack. I have had my (4) IPF's sitting in a box for about four months now waiting for a rack to put them on. Thanks for asking Tony

Mike

4XX4 · 03-30-2008, 09:12 PM

Went online at the station and showed this truck to my work buddies and talk about a group of drooling smoke eaters....

AlexJet · 03-31-2008, 12:43 PM

Quote:

Shadow-Warrior previously said:

********ARB SAFARI SNORKEL to CAI INSTALL MOD********

...

I ran inside googled up the manufacture and went through all their fitting and low and behold the perfect one, the one that I have been searching for! Number 1002-43!

I installed the reducer fitting and a small piece of PVC to make up the transition to the Snorkel to the reducer.

...

Mike, that Fernco reducer is fitting on the rectangular hole of the aFe/TRD box? Am I right? Have you used special tools for fitting or its just slides in?
I was a little bit shocked when I opened my aFe box and found the rectangular outlet instead of round:

***Shadow-Warrior*** · 03-31-2008, 04:36 PM

Yep, it fits over the hole, I hade to trim the hole by about a half inch due to it being so close to the firewall to make it fit, but yes, it fits over the intake area on the box. PM me and I'll give you my number if you have any install questions.