Toyota FJ Cruiser Forum banner

MICTUNING 2.1A Dual USB Power Socket

5K views 7 replies 6 participants last post by  iambrad4899 
#1 ·
What you see in the picture - socket only, no inline fuse or connector. Used in a 2007. It's no longer on Amazon so I can't say what other years it will fit. Blue led light when power applied. Second picture shows the front better. Free for pickup in Portland, Oregon.

Technology Electronic device Electronics Auto part Wire
 

Attachments

See less See more
2
#3 ·
What you see in the picture - socket only, no inline fuse or connector. Used in a 2007. It's no longer on Amazon so I can't say what other years it will fit. Blue led light when power applied. Second picture shows the front better. Free for pickup in Portland, Oregon.

View attachment 866738

What did you replace this dual usb with?
I understand you should have an inline fuse to prevent carbque.
 
  • Like
Reactions: Ponchera
#4 ·
lol - yessir, inline fuse. The replacement is already installed in the photo. It's Cllena Toyota USB Charger for Toyota Switch Plant with 4.2A 5V Dual USB Power Socket Blue Light (2.1/2.1A) from Amazon. The documentation wasn't clear on the old one and my assumption is that each socket was limited to 1A each. I wanted to be sure I have 2.1A on each socket including when they are both in use. Seems like my kids always jump in with almost dead phones and I've been using Waze. With Waze and sometimes Bluetooth running, 1A is enough to keep the phone battery from draining but it's not enough to charge at a reasonable rate.
 
  • Like
Reactions: BOBTAILFJ
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top