Toyota FJ Cruiser Forum banner

125k Maintiance questions

1K views 4 replies 3 participants last post by  MarkTX 
#1 ·
Ok 2007 trd spl edt AT 125,000

I've only had it a month. So far I have
Trans flush (toyota ATF WS)
Oil Change (amsoil 5w30 signature series and amsoil filter)
Spark plugs (ngk factory plugs, doing this tomorrow)
Cleaned the throttle body.
I have a Airaid CAI with dry filter coming this week.

But what else should I do? I'm thinking diff and transfer case fluids?
My coolant looks great it's factory coolant nice and clean and clear
Same with break fluid super clear.

My power stearing fluid could use a flush.

Ideas? I really want this rig to last.
 
#2 ·
Yeah rear diff, transfer case, grease the zerks.
If it needs it, rust converter / paint on the welds, etc., tighten/check torque on bolts.

Did you clean the MAF sensor when you cleaned the TB? Change the cabin air filter with the oil change?

Have the belts/hoses been replaced or at least thoroughly checked?
 
#5 · (Edited)
Sounds like your FJ is in good shape. Had 2 lbs of AC coolant added a few weeks ago, that's the only "problem" I've had on my 07 outside of routine maintenance and fixing a couple of dings and broken tail light.

I like the cabin air filters with charcoal, can find them fairly cheap on amazon along with the engine air filter.

I'll probably replace all my belts and hoses next year when I hit 60k miles; they'll be 8 years old, I don't really trust 10 year old belts and hoses regardless of mileage.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top