Toyota FJ Cruiser Forum - View Profile: debFJVT

debFJVT debFJVT is offline

MOAB SUPERSTAR

  Visitor Messages

Showing Visitor Messages 1 to 10 of 21
  1. stephous
    02-28-2019 07:51 PM - permalink
    stephous
    People love the skunk and pull in behind me just to laugh. I'm liking it...it's good karma
  2. FJREBELGIRL
    12-20-2018 11:19 AM - permalink
    FJREBELGIRL
    Hey Miss!

    I still need an email address for you to send your pics from Summit. If you're hitting Moab I would love to meet up with you, I only went to Baby Lions Back and scared the crap out of myself but I want to take a stab at the good stuff. You'll have to tell me which runs you're on and if you're leading any!!! I am going to Black Bear this year!!! I should've listened to you and changed my Gultches as that was rather slow compared to Imogene and Alpine Loop
  3. TerryMercer
    05-28-2018 10:06 AM - permalink
    TerryMercer
    Used a number of lockers on Jeeps, Rubicon and ones I built.
    Do you use Rear locker with A Trac or by themselves .
  4. debFJVT
    04-21-2018 05:03 AM - permalink
    debFJVT
    Greetings James! So you saw my rear axle, shipped over from your neighborhood There are some extremely knowledgeable FJ folks such as Bazross near Sydney who I’m sure would be happy to help. As for front locker US spec did not include them, and I did not add an aftermarket locker when I swapped to a regeared front diff...don’t care for air, so waiting for elocker technology to evolve and reach us here in the US. Where in Australia are you located? Hope you post up an intro!!
    -Deb
  5. Razorback81
    04-21-2018 04:48 AM - permalink
    Razorback81
    hey
    just had a read of your rear diff swap
    i have the 120 Prado here in Australia & am doing the same thing after going through your post
    i found a diff that has the factory E locker, but it has Air bag mounts so i need to change them

    looking at your front diff swap
    is that a factory locker in the front?
    do any of your FJ's have a factory front locker?

    cheers James
  6. Firemedic831
    03-18-2018 10:59 AM - permalink
    Firemedic831
    Good Morning DEB . question for you . . Did you have to adjust your coil overs at all . . mine sits lower in the front than the back by about a inch i would say . PS getting the rear springs in by myself was fun . I actually did the entire lift in about 4.5 hours . probably wait a week till i tackle the RLL .
  7. FJ_Ahoy
    11-26-2017 08:15 PM - permalink
    FJ_Ahoy
    yup, i asked indeed....space can be tight in there.....and the illumination is spot on ! and looks so factory.

    I too, yet again, I am getting the C1258 light, indicating 4h switch operating poorly....I replaced the H4 switch last year....dont want to again, but I'm going to do this hack and your button illuminating is inspiring.

    when you move your shifter down to H4 , and press the button....does it also illuminate the green 4x4 light, or just the yellow lights disabling trac and vac, etc.?
  8. FJ_Ahoy
    11-26-2017 08:04 AM - permalink
    FJ_Ahoy
    Good morning, noticed how you created a bypass with the 4H on your rig.

    I liked how you braided the wire up to the button....my question is on the back of push button, do you have a picture of it ? Im curious how and where you got illumination and where to ground.

    any input greatly appreciated.
  9. SemperFi4Ever
    10-26-2017 08:47 AM - permalink
    SemperFi4Ever
    Most definitely will post pics when its done. I'll be a while, I called up Mike yesterday for estimate and he said it would take about 2 months max, which is not a big deal. Here in Co, they use magnesium chloride to salt the roads and polyurethane is pretty resistant to MC so I'm gonna take a chance. If I don't like it, I can always sand it and give it a good coat of paint. I saw your bumper. I like it! That 3 hoop looks beastly and it looks great in that black powder coat. Either way I think these bumpers look good painted and bare. Kinda get the best of both worlds here.
  10. SemperFi4Ever
    10-25-2017 09:37 AM - permalink
    SemperFi4Ever
    Thanks for the quick reply! I think RESZ Fab makes the best looking bumpers. Aggressive looking and strong. I'm getting the bare metal V2 and I'm gonna coat in in a clear-coat/polyurethane to protect against rust. I really appreciate the info I'm gonna look up the thread you mentioned.

  About Me

  • About debFJVT
    Location
    The Green Mountains
  • Signature


    Member of the Month November 2016

    TLCA# 25170

  Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 06-17-2019 04:12 AM
  • Join Date: 10-21-2014
  • Referrals: 0

  Friends

Showing Friends 1 to 10 of 22
  • bazross
    • bazross is online now
  • CabinCruiser
    • CabinCruiser is offline
  • ChefJAMc
    • ChefJAMc is offline
  • Doc4216
    • Doc4216 is offline
  • dukeyjoe
    • dukeyjoe is offline
  • FinnJ
    • FinnJ is offline
  • Firemedic831
    • Firemedic831 is offline
  • FJ BRUZER
    • FJ BRUZER is offline
  • FJ Omega
    • FJ Omega is offline
  • FJDooM
    • FJDooM is offline

  Arcade Statistics

  • Leaderboard Rank: Not ranked
  • Game Started: 0
  • Games Finished: 0
  • Time Spent Playing: 0 hours, 0 minutes, 0 seconds

  Garage

    2007 Toyota FJ Cruiser
    Stelleanor

  Mentions

06-13-2019
05:35 PM - debFJVT mentioned ZerosFJ in post Re: What did you buy today (FJ related items)?
...ber accordion boots ZerosFJ showed a few posts b...
06-08-2019
08:19 AM - debFJVT mentioned BEASTWAGEN in post Re: Need help on frame compatibility
... good to check with BEASTWAGEN our resident salvage...
06-07-2019
04:35 AM - debFJVT mentioned HERSOG in post Re: Help - Engine knocking or tapping sound
HERSOG interesting post! I ...
06-01-2019
03:12 AM - debFJVT mentioned JamesP in post Re: What did you do TO your FJ Cruiser TODAY?
JamesPoop nice solution.......
05-27-2019
09:26 AM - debFJVT mentioned Dub in post Re: Spidertrax Spacers
Like DubstePear I put the blu...
05-26-2019
12:02 PM - Winterpeg mentioned debFJVT in post Re: How many skids are too many?
... link brackets like debFJVT says... that metal i...
04:56 AM - debFJVT mentioned Primer in post Re: How many skids are too many?
...rd hits. However as Primer said, crack that pum...
05-17-2019
07:31 AM - jamesepoop mentioned debFJVT in post What did you buy today (FJ related items)?
Lol isancho and debFJVT spreading knowledge!...
03:40 AM - debFJVT mentioned Boabrother4 in post Re: What did you buy today (FJ related items)?
Boabrother4 FJFool I run Spider...
03:40 AM - debFJVT mentioned FJFool in post Re: What did you buy today (FJ related items)?
Boabrother4 FJFool I run Spidertrax in...
03:40 AM - debFJVT mentioned JamesP in post Re: What did you buy today (FJ related items)?
... with rear spacers. JamesPoop is correct - offs...
02:39 AM - debFJVT mentioned Yog in post Re: Tires: Ponderings & Ruminations
Yog we are a sick bunch....
05-15-2019
06:48 AM - FJ BRUZER mentioned debFJVT in post Re: DEB PROOF FJ - Patch for sale
... rights :bandit: debFJVT - just harness me in...
05:40 AM - FJ BRUZER mentioned debFJVT in post Re: DEB PROOF FJ - Patch for sale
...senger in Deb's FJ debFJVT - I've seen her list...
05-12-2019
08:56 AM - debFJVT mentioned billythekid in post Re: WTB: Decently built FJ
...or Sale” by billythekid It’s long trav...
08:55 AM - debFJVT mentioned supertrooper in post Re: WTB: Decently built FJ
There’s a REALLY well built...
01:59 AM - debFJVT mentioned Tradewind in post Re: Raptor ECU Flash
...he tune :blueblob: Tradewind any idea when this w...
01:59 AM - debFJVT mentioned cory3122 in post Re: Raptor ECU Flash
cory3122 I canít wait to hear...
05-09-2019
05:41 AM - debFJVT mentioned JKFJ08 in post Re: Rear lower LCA look what I found
...cquired a DD :| JKFJ08 a sudden disconnect ...
05-05-2019
04:26 PM - debFJVT mentioned Iconic_ in post Re: What did you do TO your FJ Cruiser TODAY?
Iconic_ Here is the install

  Thread Tags

No results to display...

  Quotes

06-16-2019
07:05 AM - DirtyRicky quoted debFJVT in post Re: What did you buy today (FJ related items)?
Good youíre checking...keep ...
06:51 AM - debFJVT quoted DirtyRicky in post Re: What did you buy today (FJ related items)?
Do you mind sending me a pictur...
06:24 AM - DirtyRicky quoted debFJVT in post Re: What did you buy today (FJ related items)?
My discos are the same desig...
06-14-2019
08:09 AM - DirtyRicky quoted debFJVT in post Re: What did you buy today (FJ related items)?
My discos are the same desig...
07:15 AM - debFJVT quoted DirtyRicky in post Re: What did you buy today (FJ related items)?
Yes it allows for more articula...
06:00 AM - DirtyRicky quoted debFJVT in post Re: What did you buy today (FJ related items)?
Iíve run disconnects for yea...
02:45 AM - debFJVT quoted SctWgn in post Re: What did you buy today (FJ related items)?
Damn, you're making some se...
06-13-2019
05:35 PM - debFJVT quoted Iconic_ in post Re: What did you buy today (FJ related items)?
Yeah, on regular shocks, we ...
05:35 PM - debFJVT quoted CabinCruiser in post Re: What did you buy today (FJ related items)?
Yeah, on regular shocks, we just ...
06-10-2019
08:43 AM - CabinCruiser quoted debFJVT in post Re: Really, what's your weight?
I donít want to know >:DDeni...
12:30 AM - nichankinson quoted debFJVT in post 35s with 3Ē lift?
To successfully run 35s long...
06-09-2019
06:58 PM - debFJVT quoted Boabrother4 in post Re: What did you do TO your FJ Cruiser TODAY?
Can you tell me where to find th...
05:49 PM - Boabrother4 quoted debFJVT in post Re: What did you do TO your FJ Cruiser TODAY?
Sheís getting red-y >:D:x ...
05:31 PM - TrueGritCruzr quoted debFJVT in post Yankee Boy, Animas, & Huricane
Awesome pics - thanks for po...
05:22 PM - Lee44 quoted debFJVT in post Re: What did you do TO your FJ Cruiser TODAY?
Sheís getting red-y >:D:x ...
08:02 AM - TrueGritCruzr quoted debFJVT in post Re: Broke a Strut
I had the exact same thing h...
03:00 AM - debFJVT quoted goltgo in post Re: Tires: Ponderings & Ruminations
I just wanted to drop a lin...
06-08-2019
10:05 AM - debFJVT quoted CabinCruiser in post Re: What did you do WITH your FJ today, Take 2...
Admittance is the 1st step toward...
09:47 AM - CabinCruiser quoted debFJVT in post Re: What did you do WITH your FJ today, Take 2...
Trust me youíre in good comp...
09:15 AM - debFJVT quoted TexasFJ in post Re: What did you do WITH your FJ today, Take 2...
I had written that too! A fr...
 
For the best viewing experience please update your browser to Google Chrome