Well I did this tonight.. and Took Pictures of where to access these wires in the kick panel. (please read my notes, not just pictures, first time through, I connected the wrong wires)
Things that you will need to do the Job.
3 each, 20 awg wire taps.
1 each, 8-10 foot RCA or Video Cable
Electrical tape and solder.
The Harness is located in the Drivers Kick Panel. Pull the Dead pedal, door sill threshold and kick panel cover off.
Here is what you will see, In this picture I already took off the factory covering to expose wires.
Next Disconnect the connector.
Locate Wires that are needed.
The Red with the grey random marks on it is the + of the Video Feed
The White with the Grey random marks on it is the - Video Feed
The Red with yellow strip is the switch wire or signal wire.
(in this picture, the solid red and white on the left is NOT THE CORRECT WIRES, My first time through I tapped these wires and they are not correct. They don't have any random gray markings on them)
Here are my taps installed, AGAIN, the SOLID WHITE AND RED Wires on the left are not correct, you need to access the ones that are on the top row Position 2 and 3 from the right
Here is a single side of an RCA cable that I have spliced out. The center sheathed wire on the RCA is the + wire, connect that to the red wire with random gray markings.
And here is the finished Job.
It took me 2 hrs to wire everything up, install the radio and run the GPS / BT Mic And I pod connector to the dash Pocket.
Now I just have to figure out how to get the camera better visibility in the back so we can have a whole screen worth of information. yes, its 3:30 am.. im off to bed!
I hope this helps people figure this out and get it done right cause it works and its sweet!