Toyota FJ Cruiser Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Introductions & New Arrivals
    Getting the obligatory newbie post out of the way. Earlier this year my 2011 Crewmax TRD offroad was stolen from a friends house after work, major bummer, but after dealing with insurance and searching around I found the perfect replacement! Enter Silver Lining my 2007, AT, 4wd, with 203k miles...
  2. Suspension / Steering Tech
    I had measure the height of my 07 RWD FJ and the height is about 6cm lower than the original height which is 183cm. Because I bought this FJ about two years ago. I think it didn't change the shocks so I start looking for new shocks and coil spring and I found BILSTEIN 5100 was recommended by...
  3. Suspension / Steering Tech
    I am in the middle of my Bilstein 5100 install (front) and am wondering if the clocking of the spring really matters as long as it is seated properly. I have searched high and low on this site, youtube, etc. to no avail. Thanks for the help, much appreciated.
  4. Suspension / Steering Tech
    So a while ago I posted this thread in order to figure out which lift to put on my FJ. I got a bunch of really helpful advice from you guys and was ready to pull the trigger when I ran into an issue with my sound system. I decided to fix the issue and upgrade the system. As a result I lost my...
  5. Suspension / Steering Tech
    About 1 1/2 years ago I put a set of 5100's on all 4 corners, leveled the front (Notch 3) of my 07 4x4 FJ, and left everything else stock. Over the past year or so Ive been getting a lot of creaking, popping and squeaking from the front end of the truck, mostly on the drivers side, and mainly...
  6. Suspension / Steering Tech
    Hello All- I know that this has been discussed many times. No real answer in any of the 15+ threads on the subject. Hopefully this thread will lead to find the reason that this is happening... The clunking started shortly after the install of my Billstein 5100's with stock springs on the...
1-6 of 6 Results