Search Results for ‘upper control arm’

Looking for SPC Upper Control Arms. Fine with moderate use. May be willing to look at other adjustable aftermarket options if available

Hello, I’ve just installed a full OME suspension with their new UCA’s and they weren’t pre-greased so I asked the shop that did the installationto do it, after driving back home I’ve noticed some grease above the rubber boot on the drivers side: I’ve wiped it off and next day drove around...

I plan on ordering billet upper control arms soon from icon for my 07 FJ, and I plan on powder coating them to a blue that would closely match my FJ. I do not know much about powder coating and have found a couple different places that say it might affect the strength and durability of it. I...

Hi, I'm selling suspension parts that I upgraded shortly after purchasing my FJ new in 2013. These parts have been stored indoors ever since. I don't recall exactly how many miles these parts had on them before I upgraded, but I can estimate 2500'ish miles. The parts include the following, and...

Stock Bilstein suspension out of 2011 FJ cruiser with approximately 90k miles . Includes , front shocks with coils , rear shocks , rear coils and front upper control arms . All are in great condition with the usual wear and tear after 9 years that you would get . I’m located in norther Idaho but...

I recently installed a 3" rough country spacer lift on my FJ, and ordered 33's. After the installation of the tires, my cv axle snapped on the left side and had to replace both CV's and both struts. After I got done with that nightmare, I noticed every time I go over pot hole, there is a loud...

Hey folks, long time lurker first time poster here. You may have to forgive me because I'm newer to this so I'm really just looking for any advice I can get. I bought my 2007 M/T back in November and had my first issue on Friday, I had just gotten off the highway and went over a slight bump when...

I just went through a costly UCA replacement, and I am looking for preventative tips for future failures. I have a 3" ToyTec Ultimate lift (bought it that way), but I am not fully sure what brand of UCA's failed. I didn't take a pic or ask what was on there; they were not OEM or Light Racing...