Toyota FJ Cruiser Forum banner
1 - 6 of 6 Posts

·
Premium Member
Joined
·
918 Posts
Discussion Starter · #1 ·
I was going over ledges and I learned that the All Pro TCase skid is not strong enough. I did not slam down on this but slid over the skid on a sandstone ledge and you can see the results. If I can get it straightened I am going to need to get it reinforced.... So much for my $400.00 skid holding up! I have not discussed this with AP yet.

 

·
Registered
Joined
·
2,165 Posts
Well, look on the bright side, at least it's the skid plate that got bent and not the transfer case.:bigthumb:
 

·
Premium Member
Joined
·
918 Posts
Discussion Starter · #6 ·
Well, look on the bright side, at least it's the skid plate that got bent and not the transfer case.:bigthumb:
If you look at the skid it is the section that sticks down to protect the crossover pipe that has taken a beating. The rest of it has barely been touched.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top