Toyota FJ Cruiser Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
16,779 Posts
I bought the Fab Fours rear bumper sight-unseen, trusting in a good fabricating reputation. I was/have been very disappointed. Same sort of sag issues you noticed.
I was wondering if Larry would chime in on the rear bumper. He is the only person i have seen with it.
This is the first time i have heard bad news about their bumpers.
 

·
Premium Member
Joined
·
16,779 Posts
I like the front bumper. I installed mine myself in 06, and have used the hell out if it. While doing so, I Tacked all of my adjusting points with my Mig. I had a feeling that all that adjustabillity their design could end up in mis alignment after hard line pulls or jacking. Small tacks are strong and easily cut with a die gringer and disk. My bumper has not moved 1 mm.
This seems like a good solution Pilotpit.
However, a solution that i would think not be needed on an expensive bumper. If it was about 500, would slip and a tack weld would be the best solution, i would find that more reasonable buy.
 
1 - 2 of 2 Posts
Top