Toyota FJ Cruiser Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 8 of 8 Posts

·
Registered
Joined
·
296 Posts
Discussion Starter · #1 · (Edited)
After looking around at Hi Lift mounts, I decided it was crazy to spend more for a mount, than what was spent on the tool itself. Plus I wanted the jack to run across the back of the rack instead of down the side like the Gobi mount does. After some time sitting in front of Solidworks, this is what I came up with:





I then went to Home Depot and picked up $20 bucks worth of steel and hardware (regular fabricators could do this almost entirely out of scrap). These are the finished pictures. Sorry my camera was broken during the fab so I didn't get any in process pics. It is not the prettiest fab job but it works.





 

·
Registered
Joined
·
558 Posts
I like it mind if I steel you idea and make my own.
 

·
Premium Member
Joined
·
18,479 Posts
Looks terrific!
 

·
Registered
Joined
·
791 Posts

·
Registered
Joined
·
2,165 Posts
It looks great!!!:rocker: Nice job!:bigthumb:
 

·
Registered
Joined
·
296 Posts
Discussion Starter · #7 ·
Thanks guys.

The first time I went wheeling I kept waiting for the jack to fall off because of a bad weld. It held up so I guess I'm good to go.
 

·
Premium Member
Joined
·
7,729 Posts
Nice brah!! I had a design for one before but couldnt get anyone to weld it for me so I bit the bullet and bought the Gobis
 
1 - 8 of 8 Posts
Top