Toyota FJ Cruiser Forum banner
  • Hey everyone! Enter your ride HERE to be a part of MAY's Ride of the Month Challenge!

1 - 1 of 1 Posts

50 Posts
Discussion Starter · #1 ·
I was installing my secondhand RAM Brush Guard today. The brackets are supposed to utilize the (2) of the bolts that hold the steel bumper to the frame.

SO, those nuts just happen to be crazy hard to get off, and I managed to round the crap out of one of them. I still need to get it off so that I can install the second bracket and replace the nut...

Does anybody have any suggestions on how to do this? I need to get it off without ruining the stud, since I still need to use it... Also, the only rounded-nut removal tool I could find would not be deep enough the accommodate the stud the nut is on.

Anybody have any ideas?
1 - 1 of 1 Posts