Toyota FJ Cruiser Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
198 Posts
Discussion Starter · #1 ·
We installed a magnaflow cat back system on the shop truck. No matter how we tried to adjust the tip, it ran very close to the plastic bottom of the rear bumper and has been touching and melting it. Has anyone else had this issue? Magnaflow said they have had no issues with it and I am getting ready to just cut a slot into the back of the bumper.

Any thoughts?

Jeff
 

·
Registered
Joined
·
2,165 Posts
Well, if the plastic is already melting, might as well just cut hole for the tip. If you plan on getting an aftermarket bumper that really doesn't matter.
 
1 - 2 of 2 Posts
Top