Toyota FJ Cruiser Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,005 Posts
Discussion Starter #1 (Edited)
A while back I tried to get some people interested in this project of mine for an additional surface to the TG sliders. not much response but for those that were curious. I finally had them made...
original design:


fabricated:


Im not sure how it was cut(probably laser) and then it was dimple pressed for strength. Hope to weld next week
 

·
Registered
Joined
·
1,005 Posts
Discussion Starter #3
Very nice. I hope they didn't cost an arm and a leg, but I'm sure they will be worth it. Are you/how are you going to paint them?
My next step is to weld them, then probably sand down everything for some texture, prime, and then spray away. I'm not really thinking about Powder coating because once you slide on a rock its bye bye nice powder coating.
 
1 - 4 of 4 Posts
Top