Toyota FJ Cruiser Forum banner
1 - 3 of 148 Posts

· Registered
427 Posts
You can put a pin in the brakes with a 3/8" diameter pin or bolt through the hole in the side of the actuator assembly. Check to see if the holes line up properly before blindly inserting the bolt / pin. You may need to pull the lunette forward to get things aligned.

You can remove the whole surge brake assembly and just cap off the brake lines at the hubs if you want. I didn't add brakes back to mine and probably wont in the future either.

Read through my build thread over at the Expedition Portal and Mark Harley's thread too.

M101A2 Trailer Purchase & Project - Expedition Portal
1 - 3 of 148 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.