Toyota FJ Cruiser Forum banner
1 - 6 of 6 Posts

· Premium Member
Joined
·
19,414 Posts
3" would be enough, but with either lift, you will still need properly spaced wheels and body mount chop-and you'll still rub on occasion.
 

· Premium Member
Joined
·
13,974 Posts

· Registered
Joined
·
2,219 Posts
A spacer won't be necessary if you get a wheel with a small enough backspacing. Also you will need to do some fender and plastic trimming as well.:bigthumb:
 

· Registered
Joined
·
182 Posts
3" and a couple extra little mods to accomodate the 315s. body mount chop and extended bump stops in the front to avoid tire to wheel well contact in the case of extreme flexing or when catching air. i left the back alone for now...but looking into the need for extended bump stops there too. no problems yet. are you in california?
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top