Toyota FJ Cruiser Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
Was hoping I could pick a few brains here and decide the best way to wire up a set of PIAA 525's ( I believe that's the correct #....fog lights) on my new fj. I ordered a new bull bar (fire away...i get it....just not quite ready for a complete bumper yet) and also ordered lights that I would like to mount on the bar. I figured I could get a factory switch and mount it in on one of the blanks in front of console. Not being very well versed in the electrical end of automotive mods, I also figured I could take it to a Toyota dealer and have them do it for me. After calling two seperate dealerships, you may have thought I was asking them to donate a kidney and was told that they're not even sure if a factory switch would work. Any input on the difficulty of this job or of anywhere in the western Philly suburbs I could take it ? Thanks in advance for any help !
Tom
 

·
Registered
Joined
·
3,153 Posts

·
Registered
Joined
·
115 Posts
Reviving old thread...

Is it possible to use factory switches for the PIAA 525 lights? Do I need 2 switches since it's a dual-beam light?
 
1 - 5 of 5 Posts
Top