Toyota FJ Cruiser Forum banner

1 - 20 of 61 Posts

·
Registered
Joined
·
607 Posts
Discussion Starter #1
Here are a couple pictures of the Rigid Industries LED light bar that I installed yesterday. Just a couple cell phone pictures for now. I'll post better photos later. This thing is BRIGHT!









-Brett
 

·
Registered
Joined
·
440 Posts
Looking Good! I'm looking into some Rigid Industries lights myself
 

·
Premium Member
Joined
·
61 Posts
Looks GREAT! but you def need to put up some night pics!!! :)
 

·
Premium Member
Joined
·
4,256 Posts

·
Premium Member
Joined
·
1,718 Posts
Awesome, curious if you have any install pics or pics of how you ran your wiring into the rig and what switch you are using.

Awesome light set up!!
 
  • Like
Reactions: slymoan

·
Premium Member
Joined
·
1,491 Posts
I like it!!! ... I also have it. ;)
Was wondering what wiring route you took with yours. I went down the drivers A pillar. Broke all but one plastic holding pin. :(


 

·
Registered
Joined
·
607 Posts
Discussion Starter #13
Here's a pic of the switch setup.



I too wired down the a pillar and broke all but one clip haha

Night pics coming soon
 

·
Premium Member
Joined
·
18,479 Posts
Did you need the LEDs because you blacked out your headlights? :D.

Lights look great btw.
 

·
Registered
Joined
·
607 Posts
Discussion Starter #17
Hahaha the headlight covers snap right on and off, but I do tend to leave them on when I'm not out wheeling. The LED's and Lightforces are the for when I need to see. Headlights are still OK with the HIDs in them, but nothing compared to the LED light bar or the HID LightForce 170's.
 

·
Registered
Joined
·
493 Posts
Night shot!!!!!
 

·
Registered
Joined
·
121 Posts
bump for night shots before i bite the bullet and buy
 

·
Premium Member
Joined
·
9,302 Posts
bump for night shots before i bite the bullet and buy
ImageUploadedByAutoguide1313941744.180175.jpg

ImageUploadedByAutoguide1313941772.724791.jpg

ImageUploadedByAutoguide1313941882.525614.jpg

The pics don't do it justice, nor does the temporary mounting. It needed to be tilted up, but it had been a long day wrenching, and it was still 106 degrees at ten thirty at night, when pics were taken.
 
1 - 20 of 61 Posts
Top