Toyota FJ Cruiser Forum banner

1 - 5 of 5 Posts

·
Premium Member
Joined
·
9,302 Posts
Discussion Starter #1
Are the Contura Rockers available from OTRATTW compatible with the sPod switches?

Probably a dumb question, but is the rocker all that would need to be replaced to use with sPod?

I'd like continuity with all switches, even replacing the OEM switches, but would like to keep the rockers the same. In looking at threads and websites, I'm sure there is a logical reason why this isn't feasible, and I'm curious to that reason.

For the most part, if all were the same, run fogs, driving, roof, roof rear, front locker, and compressor from sPod, while changing the Atrac, rear locker, parking, and auxiliary power switches to match.

Would like for fog and driving to position left of dash, rest in lower panel.

By no means an auto electrical specialist, so all input from those who've done, or hadn't done for reason.
 

·
Premium Member
Joined
·
9,302 Posts
Discussion Starter #3
Contact Josh at SPod I am sure he could get you answer in a jiffy. Super nice folks.
They are the same.

You couldn't have said it better about John and Josh at sPod. He was digging switches out of his Tacoma to see if it had circuitry imbedded in them, in attempt to answer my question. I couldn't believe it.

Trying to switch the OEM switches with Carlins to match. Doesn't appear it's been anything that anyone else has done. Didn't stop them from trying to figure out.

Super nice guys.

Thanks,
Chris Delancy

Chris Delancy
 

·
Premium Member
Joined
·
69 Posts
銀チタン;1900455 said:
They are the same.

You couldn't have said it better about John and Josh at sPod. He was digging switches out of his Tacoma to see if it had circuitry imbedded in them, in attempt to answer my question. I couldn't believe it.

Trying to switch the OEM switches with Carlins to match. Doesn't appear it's been anything that anyone else has done. Didn't stop them from trying to figure out.

Super nice guys.

Thanks,
Chris Delancy

Chris Delancy
Chris, did OTRATTW ever figure out if you could just put a rocker on an oem FJ switch ? or.....
 
1 - 5 of 5 Posts
Top