Toyota FJ Cruiser Forum banner
1 - 5 of 5 Posts

·
fka trailman
Joined
·
849 Posts
Discussion Starter · #1 ·
i have an ultra gauge set up in the fj and its flashing pending trouble code

its P0012

p0012 "'A' Camshaft Position - Timing Over-Retarded (Bank 1)"

should i be worried?? it only says pending and no engine lights or nothing

:confused:
Thanks
Jim
 

·
Registered
Joined
·
2,698 Posts
If you're an American, you can't have a new Norinco. They're not imported to the US anymore, so you can get the much better quality Remington 870 instead.
:spam:

Capt, how do you like your Ultra Gauge? I have one. Had it since about October of last year. So far, I like it. I'm sure a Scangauge is nicer, but consider the fact that these things are like $60, I think it does a very good job.

Sorry I don't have an answer for you question.
 

·
Registered
Joined
·
2,376 Posts
maybe a spark plug issue, I would get a second opinion from a different code reader to see if it says the same thing? If persistent, I would take to the dealer.
 

·
Premium Member
Joined
·
7,729 Posts
Yeah I would clear the code and see if it returns. sometimes these things can be glitchy.
 

·
fka trailman
Joined
·
849 Posts
Discussion Starter · #5 ·
:spam:

Capt, how do you like your Ultra Gauge? I have one. Had it since about October of last year. So far, I like it. I'm sure a Scangauge is nicer, but consider the fact that these things are like $60, I think it does a very good job.

Sorry I don't have an answer for you question.
i like it. the only 2 things i did was take the distance to empty and replace it with anothe gauge and 2 was got rid of that ugly mount and made my own. i figure for 60 bucks how can i go wrong with it. the code went away for now so i will see if it comes back. anymore info on this would be great. thanks everyone

Jim
 
1 - 5 of 5 Posts
Top