Toyota FJ Cruiser Forum banner
1 - 18 of 49 Posts

· Registered
273 Posts
Discussion Starter · #1 · (Edited)
Voodoo Rider...(new video!)

Present : V o o d o o R i d e r

Stock :

Now :

Body :

-Bushwacker Fender Flares
-4Runner Body Lift Kit(1.25 ») from 4crawler
4Crawler Offroad - Custom Body Lift Kits

Engine :

-Double Yellow Optima batteries w/ selenoid
-Exhaust Flow Master
-Safari snorkel

Light :

-Fog Hella amber 500
-N-FAB light bar w/ 5x fog100w

Suspension :

-OME Medium load front/rear
-Toytec spacer in front

Protection :

-Bud Build skid plates w/cross member
- All Pro rock slider w/ Aluminium checker plate (1/16 »)

Front :

-Lucrum winch mount w/d-ring
-MilesMaker SE9500 w/synthetic winch line
(winch remote control inside the truck)

Wheell :

5x Allied Beadlock Rock-A-Thon Rock 8 chrom
5x Mickey Thompson Baja MTZ radial 315/70R17
4x custom aluminium spacer w/center hub
*this setup of wheel need to change wheel stud for IS300(competition) wheel stud…they are longer and they are perfectly fit!

Recovery Tools :

-High lift on custom roof clamp
-shovel & axe on custom roof clamp
-sling (2x16’) (2x 6’)
-snatch block
-hitch hook

Inside the FJ :

-CB Cobra 75wx st + Bandi mount
-Air tank The Source (15 lbs)
-Rear storage solution w/ 2 big box (thanks to Rick Rock)

Traveling :

-GPS Garmin Mobile w/ Palm Treo
-Sporttrac Bag 21 cub feet (for the roof)
-Hitch platform

The Familly :

Thanks for all of you, for your idea, your clear explanation and your good work.

If you have some commentary, it will be a pleasure to read...I will do my best to answer you but i'm a french person and my english is not very good.


Full JAM

· Registered
273 Posts
Discussion Starter · #7 ·
pressed send too quick , Did you add the aluminum plate to the all pro rails? looks good, ive been thinking about doing the same thing
Yes, 1/16" thick aluminium checker plate fixed with rivets. The only thing is, the paint is always get off...dont stick correctely! It's been tree time that i paint it since Chrismas vacation.

But for kid is just perfect!

· Registered
273 Posts
Discussion Starter · #29 ·
new modif with pic!

Here my new front bumper (home made) with a Lucrum winch mount

I had a rack for bag transportation on OEM roof rack:

And I modif the back door panel for more capability and know what i mean!!

Dont be shy, all your comment, make me better!
(excuse me for my french is much better)


· Registered
273 Posts
Discussion Starter · #35 ·
New mods...

here a few pictures...
the wrapout..

the rear bumbper:

new shifter...

new gears and a fron locker

New AllPro Tie rod end

New heavy duty AllPro coil spring and reinforce rear link with a angle weld on it
1 - 18 of 49 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.