Toyota FJ Cruiser Forum banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
3,257 Posts
Discussion Starter · #1 ·
I've got a very small project I'm going to start when I get back from Ouray, and it involves milling a small flat piece of 3/8" aluminum plate. It's not a major milling job, just slots and some countersunk holes.

Does anyone know of a custom milling shop in the DFW area that might be able to do a small job like that?

TIA...
 

·
Premium Member
Joined
·
3,257 Posts
Discussion Starter · #3 ·
Thanks for the reply.

When I get back from Ouray next week, I'll take the appropriate measurements and sketch out what I need fabbed. It's nothing more than a flat plate of aluminum (no curves or bends), so it should be a simple affair.

Actually, as I just noticed and judging from your sig line, you'll be interested in what I'm proposing (got anything aluminum on your FJ?) :)

PM me for details...
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top