Joined
·
104 Posts
I hate to revive an old thread, but this happened to me yesterday...twice! I was installing my ARB hitch and rear bumper and I had one weld break inside the frame where the factory tow hook bolted and one on the opposite side were there were just threaded holes where the hitch bolted too. This sucks. There is no way to hold that nut inside the frame to get the bolt really tight. The thing that pisses me off is that I was only using hand tools not air, so it’s not like I over torqued them. Anyway, the bumper and hitch is on.
Anyway else have this happen beside the original poster? I was thinking of stopping by a Toyota dealership and see what they would do. I know probably nothing as I was installing a aftermarket hitch and bumper, and blame me by over tightening them.
Anyway else have this happen beside the original poster? I was thinking of stopping by a Toyota dealership and see what they would do. I know probably nothing as I was installing a aftermarket hitch and bumper, and blame me by over tightening them.
