Toyota FJ Cruiser Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JULY's Ride of the Month Challenge!
1 - 6 of 6 Posts

·
Registered
Joined
·
1,075 Posts
Discussion Starter · #1 ·
I need a 1 7/8 ball diam ball, but what size is the shank on the ball for the Toyota Hitch reciever?
 

·
Registered
Joined
·
1,075 Posts
Discussion Starter · #3 ·
but the hole on the hitch reciever tounge is huge compare to the shank on my ball. the hole is like a inch wide.
 

·
Registered
Joined
·
1,075 Posts
Discussion Starter · #4 ·
ok in need a one inch shanked ball. the ball i have now was one from a class 2 hitch and is smaller, I need the ball for the Class 3 which is a one inch shank instead of 3/4 or something like that.
 

·
Registered
Joined
·
5,160 Posts
Roger that, put the toy ball down :)

I've never seen one of those little class II things in person before

BTW, that is a damn fine hat you have there
 

·
Premium Member
Joined
·
2,888 Posts
I need a 1 7/8 ball diam ball, but what size is the shank on the ball for the Toyota Hitch reciever?
The ball mount uses a 1" shank ball - the receiver is what is attached to the vehicle that the ball mount slides into, just so you have correct terminology when looking for the part...
 
1 - 6 of 6 Posts
Top