Toyota FJ Cruiser Forum banner
Status
Not open for further replies.
1 - 6 of 8 Posts

· Admin
Joined
·
31,313 Posts
DISCLAIMER: Part numbers, Prices & LINKS to parts do change over time.
Please do your own due diligence and verify.


This is what I have found while researching parts for my 2011 Army Green/NSSE, color code 6V7.

The reveal molding retainers to upper body/frame are screw in replaceable, 4 each.

The upper molding is reusable if a qualified/competent installer is doing the work and removes it without destroying it.

Toyota 75503-35060-AO = White
Toyota 75503-35120 = Army Green/6V7

***The windshield "tech" where I went was wrong when he said that AG was not available, white would have to ordered and sent to a body shop to be color matched. Guesstimate was $300-$500 and maybe 2 weeks turnaround time.



The 4 each side corner cowl panel clips do need to be replaced each time. FJC forum Supporting Vendor PUREFJ sells them as a set (per side) ready to go.



If the "A" pillars needs new clips, 5 each side...


Motor vehicle Vehicle Vehicle door Car Mode of transport



And have LEFT & RIGHT facing seals underneath the "A" pillars.

Font Drawing Auto part Bicycle part Line art



75566-35010 Genuine Toyota Protector, Roof Side GARNISH (toyotapartsdeal.com)

75565-35010 Genuine Toyota Protector, Roof Side GARNISH (toyotapartsdeal.com)


Technology Vehicle Electronics Wire Electronic device




Automotive exterior Floor


If the spot welded on retainer is pulled off, it'll need to be welded back on by a body shop, sealed and painted. You don't want any pin hole leaks.

RED ARROW

Bumper Automotive exterior Vehicle Auto part Trunk


Product Rectangle Triangle Line Font
 

Attachments

· Admin
Joined
·
31,313 Posts
Good info here on the removal process by Alpine_FJ

 
1 - 6 of 8 Posts
Status
Not open for further replies.
Top