Toyota FJ Cruiser Forum banner
1 - 3 of 3 Posts

· Registered
'14 6MT, Cement Gray, Off-Road/Convenience/JBL, TRD add-ons, mods mods mods mods
Joined
·
135 Posts
Discussion Starter · #1 · (Edited)
Selling a used stock air intake assembly from a 2014 FJ Cruiser. This will fit the 1GR-FE roller-rocker engine on the 2010-2014 models. Being that my TRD CAI is 50-state emissions legal, I will not be needing the stock unit if I ever decide to sell the vehicle. See the below picture for what is included. I, unfortunately, do not have all of the hardware, only the assembly (as the hardware is reused for the TRD CAI). You'll need three M6 bolts, three rubber bushings with the metal sleeves, and a couple of wire harness clips. If you don't have the stock MAF sensor, you'll need that as well.

I also will include the air filter, which only has about 3k miles on it.

$50 OBO. Located in Boston.

1161216
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top